Upgrade an IDE Hard Drive
By this, I indicate either you need it establish to whether SLAVE and MASTER. If you want to boot with the hard drive (load microsoft windows or whatever other OS off it) then you definitely want it to remain your master.
If you already have a get good at, and you ought to use that as excess space, establish this hdd to slave. This setting change uses a jumper on the back of the hard drive to be moved. It may sound challenging, but it can be easy. These jumper configurations can be found on a corner of the hdd; most have a small labeled which reports which process is which unfortunately.
After placing the jumper, take the IDE cord that runs for your primary hard drive. This is the long, usually dreary cable that will runs from your slot on the motherboard to your primary hard drive. If you will be putting your brand-new hdd in as a slave, this cable need a second connector into it not getting used. Connect this to the new slave hard disk, but tend not to disconnect that cable in the other 1TB 7200RPM FATA HARD DRIVE WITH TRAY
If that you're putting a new drive within as expert, then you have to take that cable running to your old HDD, detachment it, and hook up it to the new get good at HDD such as 10000 RPM U320 SCSI PLUGGABLE HARD DISK Drive . Within both circumstances, you will need to connect a power cable to your HDD. This runs out of your power furnish, and you will have a few extra not getting used. Connect one connector to the 4 pronged connector on the hard drive.
Once the storage device is just about all connected, make certain it is usually fastened on the chasis with both sides with the case. Sometimes it is done by removing the result, then bolting the hard drive on a particular side and the many other. This is important - if you ever only bolt one side with the HDD, it can result in corruption involving files in the HDD.
If you already have a get good at, and you ought to use that as excess space, establish this hdd to slave. This setting change uses a jumper on the back of the hard drive to be moved. It may sound challenging, but it can be easy. These jumper configurations can be found on a corner of the hdd; most have a small labeled which reports which process is which unfortunately.
After placing the jumper, take the IDE cord that runs for your primary hard drive. This is the long, usually dreary cable that will runs from your slot on the motherboard to your primary hard drive. If you will be putting your brand-new hdd in as a slave, this cable need a second connector into it not getting used. Connect this to the new slave hard disk, but tend not to disconnect that cable in the other 1TB 7200RPM FATA HARD DRIVE WITH TRAY
If that you're putting a new drive within as expert, then you have to take that cable running to your old HDD, detachment it, and hook up it to the new get good at HDD such as 10000 RPM U320 SCSI PLUGGABLE HARD DISK Drive . Within both circumstances, you will need to connect a power cable to your HDD. This runs out of your power furnish, and you will have a few extra not getting used. Connect one connector to the 4 pronged connector on the hard drive.
Once the storage device is just about all connected, make certain it is usually fastened on the chasis with both sides with the case. Sometimes it is done by removing the result, then bolting the hard drive on a particular side and the many other. This is important - if you ever only bolt one side with the HDD, it can result in corruption involving files in the HDD.
You are receiving this because you signed up for it on 2011-10-03 from IP 203.109.66.181
To fine-tune your selection of which articles to receive, just login here
using your username:
To unsubscribe please use the following link:
Unsubscribe
No comments:
Post a Comment